INSIGHT 51 EKC6044 User Manual download pdf (Page 10)

THE CERAMIC HOB

Do not use the appliance if the ceramic

glass is damaged. If a fault or crack

becomes visible, disconnect the appliance

immediately from the electricity supply and

contact your local Service Force Centre.

USING THE HOB

• To operate the hotplates, turn the control knob in

either direction to vary the heat setting.

• The highest number represents the hottest

setting and the lowest number represents the

coolest setting. Choose a setting appropriate to

the quantity and type of food to be cooked.

RECOMMENDED SAUCEPANS

Only saucepans with flat bases and close fitting lids

are recommended. The saucepan base should be

approximately the same size as the cooking area.

Ensure that new saucepans are well scrubbed to

remove edges and take off any deposits left from

manufacture.

Traditional round bottomed Woks must not be used

even with a stand. Woks with flat-bottomed bases

are available and do comply with the above

recommendations.

NOTE:

Occasionally the heated areas may be seen to switch

ON and OFF when higher heat settings are being

used. This is due to a safety device which prevents

the glass from overheating.

Some switching ON and OFF when cooking at high

temperatures, e.g. deep fat frying is quite normal,

causes no damage to the hob and little delay in

cooking times.

Excessive switching may however be caused by the

use of an unsuitable saucepan or a saucepan which

is smaller than the heated area. If excessive

switching occurs, discontinue use of the saucepan.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

INSIGHT 51 EKC6044 User Manual Page 10